Genuine Nissan Oxygen Sensors
Oxygen Sensor
Oxygen Sensor
Oxygen Sensor
Oxygen Sensor
Oxygen Sensor
Oxygen Sensor
Oxygen Sensor
Oxygen Sensor
No results found for "oxygen sensor". Here are some helpful search tips:
- Search by a part name. Example: water pump.
- Be less specific. Example: brake instead of ceramic brake.
- Remove information such as make, year or model.
- Can't find the part you are looking for? Contact us and we'll find it for you!
Genuine Nissan oxygen sensors tell the engine computer how much oxygen is left in the exhaust, and the fuel trim follows that reading. This page carries 142 of them: 107 oxygen sensors, 30 air fuel ratio sensors, 17 mounting brackets and 2 NOx sensors, all genuine Nissan or NISMO.
Genuine Nissan Oxygen and Air Fuel Ratio Sensors
Position is the first thing to get right. The upstream sensor sits ahead of the catalytic converter and drives fueling. The downstream sensor sits behind it and reports on how the converter is working. They are different parts, and on a V6 there is a pair of each, one per bank. The listing notes say it plainly: 226A0-7LG0B is the downstream sensor for the 2025 Kicks with the 2.0L and all wheel drive, and 226A0-3TA0B is the rear sensor for the 2013-2018 Altima 2.5L.
Oxygen sensor or air fuel ratio sensor
Newer engines use a wideband air fuel ratio sensor upstream. It does the same job with more resolution, and it is not interchangeable with a conventional oxygen sensor. Part 22693-BV80A is listed as an air fuel ratio sensor for the front position on the 1.6L Juke from 10/2014 and the 2017-2019 Sentra, excluding the NISMO RS. Older applications get more specific still: 22691-3Y101 is the front left upper sensor for the 2000-2001 Maxima 3.0L in California emissions trim. Year and model alone will not pick the right part, so search by VIN.
When the sensor is the actual problem
A P0130 through P0141 code points at the sensor circuit, and slow or lazy switching, a check engine light that comes back after a reset, worse fuel economy or a failed emissions test are the usual symptoms. That said, a sensor code is not always a bad sensor. An exhaust leak ahead of the sensor, a vacuum leak, a dirty mass air flow sensor or a failing converter can set the same code, so read live data before buying. Heat cycles also seize the threads over time, which is where the mounting brackets come in.
Why genuine
The engine computer is calibrated around the sensor's response curve, its heater circuit and its connector. A genuine sensor matches all three, so fuel trim stays where the factory put it and the readiness monitors set the way they should. Related pages: spark plugs and oil filters.
FAQs
Upstream or downstream, which one do I need?
The code names the sensor and the bank. Upstream is ahead of the converter, downstream behind it, and each listing states the position.
Can I use an oxygen sensor in place of an air fuel ratio sensor?
No. They read differently and the computer expects the type your engine was built with.
Do I have to replace them in pairs?
Not necessarily. Replace what the diagnosis points to, though on a high mileage engine the other sensor is often close behind.
Will the check engine light clear on its own?
After the repair the monitors need a few drive cycles to run. If the code returns, the cause was not the sensor.
Are these genuine Nissan sensors?
Yes. Every sensor here is a genuine Nissan or NISMO part sold by Courtesy Nissan of Tampa.